Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
18.1. Description of a design
18.2. Pumping of brakes
18.3. Replacement of front brake shoes
18.4. Replacement of back brake shoes
18.5. Removal of the main brake cylinder
18.6. Removal of the vacuum amplifier of brakes and adjustment of a free wheeling of a pedal of a brake
18.7. Removal of pedal knot
18.8. Removal of the signaling device
18.9. Removal of a forward brake hose
18:10. Dismantling of the forward brake mechanism
18:11. Replacement of the back wheel cylinder
18:12. Removal of a back brake hose
18:13. Check of working capacity and adjustment of the drive of the regulator of pressure of back brakes
18:14. Removal of the regulator of pressure of back brakes and its drive
18:15. Adjustment and removal of knots of the parking brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 






b678569c



18-12-snyatie-zadnego-tormoznogo-shlanga.html

18:12. Removal of a back brake hose

We perform work on a viewing ditch or the elevator.

Holding with a key "on 17" a tip of a flexible hose, a special key "on 10", covering five sides, we unscrew the union of a brake tube.

We bring a brake tube out of an opening of a tip of a flexible hose.

That brake fluid did not follow, it is possible to put on a protective cap of the union of pumping of the wheel cylinder the end of a tube.

Holding a hose tip a key "on 17", a key "on 24" we turn off the nut fixing a hose tip in an arm opening.

We remove a lock washer.

We take out a hose tip from an arm opening.

Key "on 17" we turn off a hose tip from the adapter fixed on a beam of the back bridge, holding an adapter Rozhkov a key "on 19" (or a pipe key).

We remove a back brake hose and a copper sealing ring.

We establish a hose in the return sequence, having replaced a copper sealing ring new, and we pump over a hydraulic actuator of the brake system (see. "Pumping of brakes").


"previous page
18:11. Replacement of the back wheel cylinder
following page"
18:13. Check of working capacity and adjustment of the drive of the regulator of pressure of back brakes