Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
18.1. Description of a design
18.2. Pumping of brakes
18.3. Replacement of front brake shoes
18.4. Replacement of back brake shoes
18.5. Removal of the main brake cylinder
18.6. Removal of the vacuum amplifier of brakes and adjustment of a free wheeling of a pedal of a brake
18.7. Removal of pedal knot
18.8. Removal of the signaling device
18.9. Removal of a forward brake hose
18:10. Dismantling of the forward brake mechanism
18:11. Replacement of the back wheel cylinder
18:12. Removal of a back brake hose
18:13. Check of working capacity and adjustment of the drive of the regulator of pressure of back brakes
18:14. Removal of the regulator of pressure of back brakes and its drive
18:15. Adjustment and removal of knots of the parking brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 






b678569c



18-9-snyatie-perednego-tormoznogo-shlanga.html

18.9. Removal of a forward brake hose

We hang out and remove a forward wheel.

Holding with a key "on 17" a tip of a brake hose, a special key "on 10" we unscrew the tube union.

We bring a tube out of a hose tip.

That brake fluid did not follow, it is possible to put on a protective cap of the union of pumping of the wheel cylinder the end of a tube.

Key (at difficulty — a head) "on 24" we turn off a nut of fastening of the union of a brake hose to a body arm, holding a hose tip from a provorachivaniye a key "on 17".

We bring the union out of an arm opening. Do not lose at the same time a lock washer!

Rozhkov a key "on 17" we turn off a hose tip from the brake cylinder.

If the tip does not turn away, we use a cap key "on 17", having put on it a hose.

Connection of a hose with the cylinder is condensed with a copper ring which at assembly should be replaced new.

We remove a brake hose.

We establish a hose in the return sequence and we pump over the brake system (see. "Pumping of brakes").


"previous page
18.8. Removal of the signaling device
following page"
18:10. Dismantling of the forward brake mechanism