Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
19.1. General information
19.2. Replacement of safety locks and relay
19.3. Removal of the assembly block
19.4. Zazhikaniye switch
19.5. Removal of the switch of ignition
19.6. Rechargeable battery
19.7. Cooling system fan electric motor
19.8. Generator
19.9. Starter
19:10. Headlights
19:11. Understeering switch
19:12. Sound signal
19:13. Cleaner and washer of a windshield
19:14. Back door glass heating system
19:15. Control devices
19:16. Control system of the economizer of compulsory idling (ECI)
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 






b678569c



19-5-snyatie-vyklyuchatelya-zazhiganiya.html

19.5. Removal of the switch of ignition

We disconnect a wire of "weight" from the rechargeable battery. We remove casings of a steering column (see. "Understeering switch"). Understeering switches and a steering wheel can be not removed (on a photo they are removed for descriptive reasons).

We separate blocks of plaits of wires of the switch of ignition.

Key "on 10" we turn off two bolts of fastening of the switch of ignition if their heads are not cut off at installation.

If heads of bolts are cut off, we weaken their inhaling a chisel and we turn off passatizham.

We remove the switch of ignition and a bracket of its fastening.

By the Shlitsevy screw-driver it is turned off two screws of fastening of contact group of the switch of ignition...

... we remove it from the case...

... also we disconnect an overlay of the switch of ignition from contact group.

At assembly of the switch of ignition of a pro-point on an internal surface of contact group we combine with ledges on the switch case. We install the ignition switch in the return sequence. If necessary we break heads of fixing bolts.


"previous page
19.4. Zazhikaniye switch
following page"
19.6. Rechargeable battery