Service of IZh 2126
1. General information
2. Engine UEPA-331
2.1. Description of a design
2.2. Oil replacement
2.3. Replacement of laying of a cover of a head of the block of cylinders
2.4. Check and adjustment of thermal gaps in the drive of valves
2.5. Adjustment of a tension of a chain of the drive of the camshaft
2.6. Removal of a natyazhitel of a chain
2.7. Removal of the drive of the distributor of ignition
2.8. Removal of a chain of the drive of the camshaft
2.9. Replacement of a forward epiploon of a bent shaft
2.10. Replacement of a back epiploon of a bent shaft
2.11. Replacement of the sensor of pressure of oil
2.12. Adjustment and replacement of the reducing valve of the oil pump
2.13. Removal of gear wheels of the oil pump
2.14. Removal of an inlet pipe
2.15. Removal of a final collector
2.16. Removal and dismantling of a head of the block of cylinders
2.17. Removal of support of the power unit on the car with the engine UEPA-331
2.18. Replacement of laying of the pallet of a case on the car
2.19. Removal of an oil receiver
2.20. dismantle of tsilindroporshnevy group (TsPG) on the car
2.21. Removal of the engine
2.22. Dismantling and assembly of the engine
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 






b678569c



2-2-zamena-masla.html

2.2. Oil replacement

We perform work on a viewing ditch or the elevator

We replace oil on the heated-up engine.

Tetrahedron "on 9" we turn off a stopper of the pallet of a case and we merge oil in capacity not less than 5 l.

Oil discharge duration not less than 10 min. We wrap a drain stopper.

The stripper turned off an oil filter...

... also we take out it.

Having oiled laying of a new oil filter engine, navorachivay the filter on the union. After contact of laying of the filter with the privalochny plane dovorachivay the filter on 3/4 turns. Having uncovered a maslozalivny mouth, we fill in oil. Level of oil is controlled according to the index (probe) — level has to be between tags of "max" and "min". We start the engine. After on the dashboard the control lamp of pressure of oil will go out, we stop the engine. We double-check oil level. If necessary we add.


"previous page
2.1. Description of a design
following page"
2.3. Replacement of laying of a cover of a head of the block of cylinders