Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
12.1. Description of a design
12.2. Oil replacement
12.3. Replacement of an epiploon of a main shaft
12.4. Replacement of an epiploon of a secondary shaft
12.5. Removal of the drive of a speedometer
12.6. Removal of the transmission
12.7. Removal of the forward bearing of a main shaft of the transmission
12.8. Dismantling and assembly of the transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 






b678569c



12-7-snyatie-perednego-podshipnika-pervichnogo-vala-korobki-peredach.html

12.7. Removal of the forward bearing of a main shaft of the transmission

The bearing is removed for replacement.

Work is carried out on a viewing ditch or the elevator.

We remove an engine flywheel (see. "Replacement of a back epiploon of a bent shaft").

For removal of the bearing it is possible to use the elementary stripper. The bolt of M8 60-80 mm long is inserted by a head into an opening of an internal ring of the bearing so that it was hooked for a back edge of a ring. We wedge M8 bolt in an internal ring of the bearing any core with a diameter of 7 mm (it is possible to use the bolt or a hairpin of M8 which are ground off or flattened to the size of 7 mm). We put on a suitable piece of a pipe (with an internal diameter of 36-40 mm), a big washer a bolt and nazhivlyay a nut.

Tightening a nut, we press off the bearing.

Bearing and stripper.

The bearing can be beaten out...

... using a shock stripper with the hook hooked for an internal ring.

We press the bearing a suitable piece of a pipe, leaning only on an external ring of the bearing.

We establish the removed details in the return sequence.


"previous page
12.6. Removal of the transmission
following page"
12.8. Dismantling and assembly of the transmission