Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
12.1. Description of a design
12.2. Oil replacement
12.3. Replacement of an epiploon of a main shaft
12.4. Replacement of an epiploon of a secondary shaft
12.5. Removal of the drive of a speedometer
12.6. Removal of the transmission
12.7. Removal of the forward bearing of a main shaft of the transmission
12.8. Dismantling and assembly of the transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 






b678569c



12-5-snyatie-privoda-spidometra.html

12.5. Removal of the drive of a speedometer

Work is carried out on a viewing ditch or the elevator.

On the car with a mechanical speedometer the flexible shaft is disconnected from a reducer of its drive (see. "Removal of a flexible shaft of the drive of a speedometer").

If the car is completed with a combination of devices with an electronic speedometer, then the speed sensor is attached to a reducer of its drive.

We disconnect the socket from the sensor.

Rozhkov a key "on 10" we turn off a nut of a hairpin of fastening of a reducer of the drive of a speedometer to a transmission case...

... also we remove a speedometer drive reducer.

If for removal of a reducer there is not enough place in a floor tunnel, we establish an adjustable emphasis under a transmission case, we disconnect a cross-piece of a back support of the power unit from body arms (see. "Removal of support of the power unit on the car with the VAZ-2106 engine"). Having a little lowered the transmission on an emphasis...

... a piece of a pipe or an assembly shovel we wring out the transmission to the right and we remove a reducer.

We establish knots and details in the return sequence. We oil a sealing ring of the drive gearbox.


"previous page
12.4. Replacement of an epiploon of a secondary shaft
following page"
12.6. Removal of the transmission