18-6-snyatie-vakuumnogo-usilitelya-tormozov-i-regulirovka-svobodnogo-khoda-pedali-tormoza.html
18.6. Removal of the vacuum amplifier of brakes and adjustment of a free wheeling of a pedal of a brake We remove the main brake cylinder (see. "Removal of the main brake cylinder").
Having hooked the screw-driver...
... we take out the backpressure valve from the case of the amplifier...
... and its rubber sealant.
In salon of a passatizhama rasshplintovyvay piston pusher fork finger...
... we take out the forelock...
... and finger.
Also in salon by a head "on 13" with the extender it is turned off four nuts of fastening of the vacuum amplifier and pedal knot to a body front guard.
We bring a pusher of the amplifier out of an opening of a guard of a front and we take the vacuum amplifier from a motor compartment.
We establish the vacuum amplifier of brakes in the return sequence. At installation of the backpressure valve we moisten it and a sealant with the getting liquid of the WD-40 type. Before installation of the main brake cylinder...
... we control vystupany heads of its adjusting bolt concerning the plane of fastening of a flange of the main brake cylinder which has to make 1,25-0,2 mm.
For adjustment of a vystupaniye of a head of a bolt we rotate it a key "on 8".
For removal of the switch of a stoplight...
... we disconnect from it wires.
Having weakened a lock-nut a key "on 19". a key "on 14" we turn out the stoplight switch from an arm of pedal knot...
... also we take out the switch.
We install the stoplight switch in the return sequence and we regulate its situation, rotating the switch case in an arm (at the disconnected wires). The switch of a stoplight is installed so that its button concerned a pedal emphasis at a free wheeling of a pedal of a brake of 3-5 mm. In this situation we tighten a lock-nut.
|