Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
5.1. Description of a design
5.2. Replacement of the fuel filter of thin cleaning
5.3. Replacement of a replaceable element of the air filter
5.4. Removal of the case of the air filter
5.5. Removal of the fuel pump on the car with the engine UEPA-331
5.6. Removal of the fuel pump on the car with the VAZ-2106 engine
5.7. Dismantling of the fuel pump
5.8. Removal of the fuel tank and fuel receiver
5.9. Removal of a cable of the drive of butterfly valves of the carburetor
5.10. Removal of a cable of the drive of the air gate of the carburetor
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 






b678569c



5-9-snyatie-trosa-privoda-drosselnykh-zaslonok-karbyuratora.html

5.9. Removal of a cable of the drive of butterfly valves of the carburetor

The cable of the drive of butterfly valves of the carburetor on cars with engines UEPA-331 and VAZ-2106 is established almost equally except for fastening of a cover of a cable. On the engine UEPA-331 the cover of a cable fastens to the arm established on two hairpins of fastening of the carburetor to an inlet pipe, and on the VAZ-2106 engine — to an arm of a cover of a head of the block of cylinders.

Operations on dismantle of a cable are shown on the car with the engine UEPA-331. We remove the case of the air filter (see. "Removal of the case of the air filter").

By the Shlitsevy screw-driver it is hooked and we remove a plastic tip of a cable from a carburetor lever lug.

Two keys "on 13" raskontrivay nuts of fastening of a cover of a cable of the drive of gates to an arm.

We bring a cable out of an arm cut.

In salon in the top part of a pedal of the drive of butterfly valves we bring a cable tip out of a pedal cut.

Having taken out the rubber plug of a cover of a cable from an opening of a motor board...

... we remove a cable.

We establish a cable in the return sequence, checking whether butterfly valves open completely and closed. If necessary we regulate the provision of a cover of a cable nuts.


"previous page
5.8. Removal of the fuel tank and fuel receiver
following page"
5.10. Removal of a cable of the drive of the air gate of the carburetor