Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
17.1. Description of a design
17.2. Adjustment of the steering mechanism
17.3. Removal of a steering wheel
17.4. Removal of a steering column
17.5. Removal of the lower cardan hinge
17.6. Removal of an external tip of steering draft
17.7. Replacement of a cover of a lath
17.8. Removal of the steering mechanism
17.9. Dismantling of the steering mechanism
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 






b678569c



17-6-snyatie-naruzhnogo-nakonechnika-rulevojj-tyagi.html

17.6. Removal of an external tip of steering draft

Work is carried out for replacement of a tip.

We hang out and remove a wheel. We turn a wheel against the stop to the left when replacing the right tip and vice versa.

Passatizhami we take out the forelock...

... and a cap key "on 17" we turn off a nut of fastening of a tip to the lever of a rotary fist.

Stripper we press off a tip finger from the lever of a rotary fist.

It is possible to use a bifurcate stripper.

In the absence of strippers we turn off a nut of fastening of a finger not up to the end.

We implant an assembly shovel a vraspor between a steering rod end and the lever of a rotary fist.

Wringing out an assembly shovel a tip down, we strike with the hammer blows to a lever end face.

We take out a tip finger from the lever of a rotary fist.

Rozhkov a key "on 22" raskontrivay a nut, holding a tip of steering draft from a provorachivaniye for ledges Rozhkov a key "on 24".

Including carving rounds, we turn off a tip.

The new tip is established in the return sequence, wrapping it on the same quantity of rounds. At the same time the corner of a convergence of wheels of the car will change a little, but its small deviation will allow to reach under the own steam the place of adjustment which after this work is obligatory.


"previous page
17.5. Removal of the lower cardan hinge
following page"
17.7. Replacement of a cover of a lath