Service of IZh 2126
1. General information
2. Engine UEPA-331
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
19.1. General information
19.2. Replacement of safety locks and relay
19.3. Removal of the assembly block
19.4. Zazhikaniye switch
19.5. Removal of the switch of ignition
19.6. Rechargeable battery
19.7. Cooling system fan electric motor
19.8. Generator
19.8.1. Description of a design
19.8.2. Check of the generator
19.8.3. Removal of brush knot and regulator of tension of the generator 58.3701
19.8.4. Removal and dismantling of the generator 58.3701
19.8.5. Removal of the regulator of tension and brush knot of the generator 37.3701
19.8.6. Removal and dismantling of the generator 37.3701
19.9. Starter
19:10. Headlights
19:11. Understeering switch
19:12. Sound signal
19:13. Cleaner and washer of a windshield
19:14. Back door glass heating system
19:15. Control devices
19:16. Control system of the economizer of compulsory idling (ECI)
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 









индивидуалки

b678569c


19-8-5-snyatie-regulyatora-napryazheniya-i-shhetochnogo-uzla-generatora-37-3701.html

19.8.5. Removal of the regulator of tension and brush knot of the generator 37.3701

Work can be performed, without removing the generator from the car. Operations are for descriptive reasons shown on the removed generator.

We disconnect a wire of "weight" from the rechargeable battery.

We disconnect a wire tip from tension regulator conclusion (a conclusion "61").

By the crosswise screw-driver it is turned off two screws of fastening of the regulator of tension and brush knot to the generator case...

... also we remove tension regulator assembled with brush knot.

We install tension regulator with brush knot in the return sequence.


"previous page
19.8.4. Removal and dismantling of the generator 58.3701
following page"
19.8.6. Removal and dismantling of the generator 37.3701