Service of IZh 2126
1. General information
2. Engine UEPA-331
2.1. Description of a design
2.2. Oil replacement
2.3. Replacement of laying of a cover of a head of the block of cylinders
2.4. Check and adjustment of thermal gaps in the drive of valves
2.5. Adjustment of a tension of a chain of the drive of the camshaft
2.6. Removal of a natyazhitel of a chain
2.7. Removal of the drive of the distributor of ignition
2.8. Removal of a chain of the drive of the camshaft
2.9. Replacement of a forward epiploon of a bent shaft
2.10. Replacement of a back epiploon of a bent shaft
2.11. Replacement of the sensor of pressure of oil
2.12. Adjustment and replacement of the reducing valve of the oil pump
2.13. Removal of gear wheels of the oil pump
2.14. Removal of an inlet pipe
2.15. Removal of a final collector
2.16. Removal and dismantling of a head of the block of cylinders
2.17. Removal of support of the power unit on the car with the engine UEPA-331
2.18. Replacement of laying of the pallet of a case on the car
2.19. Removal of an oil receiver
2.20. dismantle of tsilindroporshnevy group (TsPG) on the car
2.21. Removal of the engine
2.22. Dismantling and assembly of the engine
3. VAZ-2106 engine
4. Cooling system
5. Power supply system
6. Carburetor
7. System of ignition of the engine UEPA-331
8. System of ignition of the VAZ-2106 engine
9. System of production of the fulfilled gases
10. Coupling
11. IZh-2126 transmission
12. VAZ-21074 transmission
13. Cardan transfer
14. Zadny Bridge
15. Forward suspension bracket
16. Back suspension bracket
17. Steering
18. Brake system
19. Electric equipment
20. Body
21. System of ventilation and heating
22. Features of a design of the IZh-2717 car
23. Appendix
24. Care of a car body
 






b678569c



2-19-snyatie-maslopriemnika.html

2.19. Removal of an oil receiver

We remove the engine case pallet (see. "Replacement of laying of the pallet of a case on the car").

Holding a bolt from a provorachivaniye a cap key "on 10", the same key we turn off a nut of fastening of an arm of an oil receiver to the arm established on hairpins of a cover of the second radical bearing of a bent shaft.

Cap key "on 10" we turn off two bolts of fastening of a flange of a tube of an oil receiver to the block of cylinders of the engine.

We remove an oil receiver.

The oil receiver flange joint with the block of cylinders of the engine is condensed with laying.

Carefully we wash out an oil receiver, in particular its grid, from deposits of dirt and oil. Having replaced laying, we establish an oil receiver in the return sequence.


"previous page
2.18. Replacement of laying of the pallet of a case on the car
following page"
2.20. dismantle of tsilindroporshnevy group (TsPG) on the car